FF5000 FLANGE FACER

    FF5000-2-600x400

    FF5000-2-600x400

    FF5000 FLANGE FACER

    A two-piece mounting system makes this low profile unit easy to set up and align. Lightweight and simple to use whether you’re facing, beveling or turning valve, pipe or pump flanges. Facing diameters range from 5 to 24 inches (127 to 609.6 mm).

    Specification:

    Facing Diameter: 5 – 24 inches (127 – 609.6 mm)
    Milling Diameter: N/A
    ID Mounting Diameter: 5 – 18 inches (88.9 – 457.2 mm)
    OD Mounting Diameter: N/A
    Minimum Swing Diameter: 19 inches (482.6 mm)
    Power Option: Pneumatic

    Product Advantages

    Quick and Easy Setup & Removal
    Separate mounting chuck.
    All centering and leveling is done on the chuck.
    Loosen one bolt and machine can be removed from the chuck without disturbing alignment or calibration.
    Lightweight
    Body of machine weighs only 60 lbs (27.2 kg).
    Smallest mounting chuck weighs about 5 lbs (2.2 kg).
    Low Profile
    Right angle motor mount.
    Machine extends only 7.6 inches (193.0 mm) above flange.
    Safe and Quiet Operation
    Stationary feed rate selector.
    Machine is controlled without touching any moving parts.
    Exhaust air is routed through body of machine for increased muffling.
    Simplified Operation
    Single selector switch for bidirectional radial feed or vertical down-feed.
    One wrench size for clamping jaws and body draw bolt.
    Cuts Chamfers and Grooves
    Compound tool head and down-feed for cutting angles and grooves.