" "
Egytorc - partners
Egytorc – Products & Services
02/05/2019
Micro-Adjust-Boring-Head-for-Large-Boring-Bars-640x400.jpg
Line Boring Machine
12/01/2021
Show all

News

blog-news1

blog-news1

Flange Facing

Why use Flange Facing ?

Performance, versatility, and safety. Delivers high-torque performance to quickly re-surface flanges and repair sealing and bearing surfaces efficiently and cost-effectively. Can be configured in either ID, OD, or surface-mount configurations for a variety of machining applications, with a quick and easy changeover. Facing diameters range from 11.8 to 60 inches (299.7 to 1524.0 mm).

Line Boring & Welding

What is line boring machine ?

The line boring machine is used to enlarge a hole that has been drilled or cast using one or more cutting tools fixed in the boring head. Doing so can make the accuracy of the aperture higher If the holes in the machined part are not collinear, it may cause misalignment, vibration or even system failure. If a small amount of misalignment is introduced, usually the machine cannot work at all. This is why this type of repair is so common.

Cold Cutting & Beveling

Why use of pipe cold cutting machine ?

The pipe cold bevel machine is designed for cutting, beveling pipelines for production and repairs. The transportable pipe cold bevel machine, can be nearly used without limitations on site. The machines are extremely lightweight, do not require much space and convince by a simple installation. They distinguish by its numerous machinery application possibilities. Following preparations are possible: Radial cutting of pipes Beveling of pipes Simultaneous cutting and beveling of pipes The pipe cold cutting machine has three different motor possibilities: Compressed air, electric or a hydraulically drive. Any cutting tool is possible.

Hydraulic Boltensioner Machines

Why use Boltensioner ?

To obtain a leak-free flange connection, a proper gasket installation is needed, the bolts must be assign on the correct bolt tension, and the total bolt strength must be evenly divided over the whole flange face. With Torque Tightening, the correct bolt tension can be realized. Correct tightening of a bolt means making the best use of the bolt's elastic properties. To work well, a bolt must behave just like a spring. In operation, the tightening process exerts an axial pre-load tension on the bolt. This tension load is of course equal and opposite to the compression force applied on the assembled components. It can be referred to as the "tightening load" or "tension load.

Torque Wrench & Flange Management

Why use Torque Wrench & Flange Management ?

Flange Managementis used for the planning, data capture, analysis and reporting of all activities related to the inspection, maintenance and testing of bolted joints and offer simplified management and control of complex process systems..

Torque Wrench is the general name for a hand-guided screwing tool, and used to precisely set the force of a fastening such as a nut or bolt. It allows the operator to measure the rotational force (torque) applied to the bolt so it can be matched to the specifications.
Step 1

Select the hydraulic cylinder that best suits the application

Step 2

Select a hydraulic pump with adequate oil output and reservoir capacity to power cylinder.

Step 3

Select pump and valve option that is best suited to the cylinder and application.